Product preview – Texas Instruments TMS320C6454 User Manual
Page 135
www.ti.com
PRODUCT PREVIEW
TMS320C6454
Fixed-Point Digital Signal Processor
SPRS311A – APRIL 2006 – REVISED DECEMBER 2006
7.7.3.9 PLLDIV Ratio Change Status Register
Whenever a different ratio is written to the PLLDIVn registers, the PLLCTRL flags the change in the
PLLDIV ratio change status registers (DCHANGE). During the GO operation, the PLL controller will only
change the divide ratio of the SYSCLKs with the bit set in DCHANGE. Note that changed clocks will be
automatically aligned to other clocks. The PLLDIV divider ratio change status register is shown in
and described in
.
31
16
Reserved
R-0
15
5
4
3
2
0
Reserved
SYS5
SYS4
Reserved
R-0
R-0
R-0
R-0
LEGEND: R/W = Read/Write; R = Read only; -n = value after reset
Figure 7-19. PLLDIV Divider Ratio Change Status Register (DCHANGE) [Hex Address: 029A 0144]
Table 7-27. PLLDIV Divider Ratio Change Status Register (DCHANGE) Field Descriptions
Bit
Field
Value
Description
31:5
Reserved
0
Reserved. The reserved bit location is always read as 0. A value written to this field has no effect.
4
SYS5
Identifies when the SYSCLK5 divide ratio has been modified.
0
SYSCLK5 ratio has not been modified. When GOSET is set, SYSCLK5 will not be affected.
1
SYSCLK5 ratio has been modified. When GOSET is set, SYSCLK5 will change to the new ratio.
3
SYS4
Identifies when the SYSCLK4 divide ratio has been modified.
0
SYSCLK4 ratio has not been modified. When GOSET is set, SYSCLK4 will not be affected.
1
SYSCLK4 ratio has been modified. When GOSET is set, SYSCLK4 will change to the new ratio.
2:0
Reserved
0
Reserved. The reserved bit location is always read as 0. A value written to this field has no effect.
C64x+ Peripheral Information and Electrical Specifications
135