RAD Data comm LRS-24 - Manual (Page 90)

Appendix B LRS-PS-FEED Power Supply LRS-24 Installation and Operation Manual
B-2 Site Requirements
Figure B-1. AC-Powered LRS-PS-FEED Front Panel
Figure B-2 shows the rear panel of the LRS-PS-FEED unit, which includes POWER
indicator that lights when the unit is powered (ANSI option).
Figure B-2. LRS-PS-FEED Rear Panel
DC-Powered Unit
Figure B-3 shows the front panel of the DC-powered LRS-PS-FEED unit. The front
panel includes a POWER indicator, a DC input power connector, and a fuse.
Figure B-3. DC-Powered LRS-PS-FEED Front Panel
The output voltage (PHANTOM OUT) is provided by means of a short cable
terminated in a five-pin connector.
The rear panel of the DC-powered LRS-PS-FEED unit is similar to that of the
AC-powered unit (see Figure B-2).
B.3 Site Requirements
AC Power
Install AC-powered LRS-PS-FEED units within 1.5m (5 feet) of an easily accessible
grounded AC outlet capable of furnishing the required supply voltage, 115 VAC or
230 VAC.
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com