RAD Data comm LRS-24 - Manual (Page 128)

Appendix D CM-2 Management Commands LRS-24 Installation and Operation Manual
D-26 Defining Auto-Configuration
Hub Configuration Operations
You can send or execute Hub Configuration files.
➤ To execute a Hub Configuration file:
1. Select 1 from the Auto-Configuration Menu.
2. Select file 4 or 5 (if the Hub files exist) in the Edit Configuration screen
(see Figure D-23).
The Operations for HUB Configuration screen appears (see Figure D-24).
OPERATIONS FOR HUB CONFIGURATION FILE
Execute file: [NO/YES]
Send file via: [N/A/TFTP/XMODEM]
To select an option press ‘f’ for forward or ‘b’ for backward.
Figure D-24. Operations For Hub Configuration File
3. Select YES to execute the configuration.
An error message is returned if the configuration specifies parameters but:
ƒ Slot is empty
ƒ Modem in slot does not exist
ƒ Type of modem in slot doesn’t match type in file configuration.
4. Select method for sending file to the station.
− N/A: file is not sent
− TFTP: Upload via LAN screen appears (see Figure D-25)
− XMODEM
5. Press to continue the process.
Upload via LAN
IP Address of TFTP client: [000.000.000.000]
Filename: [Filename]
Figure D-25. Upload via LAN Screen
6. Enter station IP Address and Filename.
After the TFTP process has completed, a confirmation screen will appear
(see Figure D-26).
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com