Command fields – RAD Data comm LRS-24 User Manual

Page 107

LRS-24 Installation and Operation Manual

Appendix D CM-2 Management Commands

Defining LRS-24 And CM-2 SNMP Agent Parameters

D-5

3. Press to move to the next field.
4. Continue until all the required lines have been filled in.
SNMP community names are case-sensitive.

5. Press to load all the data appearing on the screen into the CM-2

memory.

A typical data form is shown in Figure D-2.

LRS HUB SETUP

HUB NAME : 'name'

HUB NUMBER : '1234'

HUB LOCATION IS : 'location'

CONTACT PERSON IS : 'person'

CM CARD SOFTWARE VER : 0.0 MAIN CARD HW REV : VER 2.0

INTERFACE CARD HW REV: 0.0

TIME (HH:MM:SS) : 16:18:37 DATE : 2000-05-23

IP ADDR : 192.114.24.30 IP MASK : 255.255.255.0

READ COMMUNITY : PUBLIC

TRAP COMMUNITY : PUBLIC

READ/WRITE COMMUNITY : PUBLIC

DEFAULT GATEWAY : 000.000.000.000

BURN IN MAC ADDRESS : 9920D2FE838D BOOTP ON/OFF : OFF

BOOTP TIME OUT : 1 SEC BOOTP RETRIES : 30

HUB IP MODE : MULTIPLE

SERIAL LINE PROTOCOL : RS232

STATION CLOCK : INTERNAL CLOCK

Figure D-2. LRS Hub Setup

Command Fields

Table D-2 describes fields on the data form.

Table D-2. DEF HUB Command Fields

Field Name

Description

Options

HUB NAME

Logical name assigned to the LRS-24 unit.

Maximum 10 alphanumeric
characters

Default: LRS-24

HUB NUMBER

LRS-24 management number. The two least
significant digits are displayed on the STAT/ADD
display located on the front panel of the CM-2

module.

Mmaximum four hexadecimal
digits

Default: 5544

Note

Order from: Cutter Networks

Ph:727-398-5252/Fax:727-397-9610