RAD Data comm LRS-24 - Manual (Page 124)

Appendix D CM-2 Management Commands LRS-24 Installation and Operation Manual
D-22 Defining Supervision Terminal Type
• Move cursor to the right by one position.
The terminal types supported by the CM-2 module are: VT-52, VT-100, TV-920,
FREEDOM-100, FREEDOM-110, FREEDOM-220, and terminals that are
compatible with these types. Selecting an incorrect terminal type may prevent
correct display of data entry forms on the terminal.
Table D-6 shows the codes used by the supported terminals.
Table D-6. Terminal Types
Function Terminal Type
TV- 920 VT-52 VT-100 Freedom-100
Freedom-110
Freedom-220
Clear Screen 1B2A0000 N/A 1B5B324A 1B2A0000 1B5B324A
Cursor Home 1E000000 1B480000 1B5B4800 1E000000 1B5B4800
Cursor Right 0C000000 1B430000 1B5B3143 0C000000 1B5B0143
This command is always addressed to the CM-2 module. Therefore the node
address must always be 13.
Format
NODE 13 DEF TRM
Procedure
➤ To configure the CM-2 module for the desired terminal:
• Type: NODE 13 DEF TRM .
The terminal selection form appears. A typical form is shown in
Figure D-20.
DEFINE TERMINAL TYPE
1. TV920
2. VT52
3. VT100
4. FREEDOM 100/110
5. FREEDOM 200
DEFAULT TYPE IS VT 100
ENTER TERMINAL TYPE No. -->
Figure D-20. Define Terminal Type Screen
➤ To select a terminal:
1. Type the corresponding number.
2. If the resulting display is not correct, try selecting another terminal.
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com