RAD Data comm LRS-24 - Manual (Page 123)

LRS-24 Installation and Operation Manual Appendix D CM-2 Management Commands
Defining Supervision Terminal Type D-21
MODEM SETUP
MODEM NAME: ASMI-31CQ(m)
DEFINE MAODEM PORT NUMBER : 1
MODEM STATUS : MASTER PERMANENT
SELECT MODEM : MODEM 1 LOCAL
SYNC/ASYNC : SYNC CHARACTER LENGTH : N/A
No. STOP BIT : N/A DATA RATE : 128K
PARITY : N/A CD SENSE : N/A
CLOCK SOURCE LOC/REM: L(INT)R(RCV) EXT SOURCE: Modem #1 PORT: DCE-EXT
INTERFACE : 2 WIRE RTS/CTS DELAY (0:255) : N/A
RTS TO DCD : YES DTR TO DSR : N/A
OUTPUT LEVEL : N/A INPUT LEVEL : N/A
OUTPUT IMPEDANCE : N/A ohm INPUT IMPEDANCE : N/A ohm
CARRIER CONTROL : N/A ERROR COLLECTION : N/A
RATE ADAPTION METHOD: PRIVATE AIS : N/A
LINE CODING : N/A PHANTOM : N/A
T1 LINE LENGTH : N/A
BRIDGING : N/A ETHERNET NODE : N/A
MASK SIGNAL STATUS : DATA : NO RTS:NO TD: NO RD: NO
DCD : NO TEST: NO ERR: NO LOS: NO
Figure D-19. Modem Setup Screen
Use the general procedures to define the parameter values, as required.
The contents of the form depend on the module type. Refer to the Installation and
Operation Manual of the corresponding module for detailed information.
D.10 Defining Supervision Terminal Type
Purpose
Defines the supervision terminal type.
This command enables the CM-2 module to provide the proper control codes to
the supervision terminal and in particular the codes for the following terminal
control functions:
• Clear screen
• Move cursor to screen home position
Note
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com