RAD Data comm LRS-24 - Manual (Page 110)

Appendix D CM-2 Management Commands LRS-24 Installation and Operation Manual
D-8 Defining CM-2 Download Parameters
D.3 Defining Management Stations
Purpose
Define the list of management stations to receive traps generated by the CM-2
module. You can define up to 10 management stations, by specifying their IP
addresses. The trap community is defined by means of the DEF HUB command.
This command is always addressed to the CM-2 module, therefore the node
address must always be 13.
Format
NODE 13 DEF MNG
Procedure
➤ To define management stations that will receive traps:
1. Type: NODE 13 DEF MNG .
The first line of the data entry form appears.
2. Type in the desired IP address in the dotted-quad format for each station to be
defined.
3. Press to display the next line.
4. Continue until all 10 lines display the required addresses.
5. To delete an IP address, enter 000.000.000.000.
A typical data form is shown in Figure D-3.
HUB NMS TRAP UPDATE
No. IP ADDR
1 192.114.24.45
2 192.114.24.70
3 000.000.000.000
4 000.000.000.000
5 000.000.000.000
6 000.000.000.000
7 000.000.000.000
8 000.000.000.000
9 000.000.000.000
10 000.000.000.000
Figure D-3. Hub NMS Trap Update Screen
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com