RAD Data comm LRS-24 - Manual (Page 46)

Chapter 2 Installation and Setup LRS-24 Installation and Operation Manual
2-18 Interfaces and Connections
LRSI-F-CM1
S
T
A
T
I
O
N
C
L
K
M
A
N
A
G
E
M
E
N
T
R
S
2
3
2
Figure 2-9. Typical LRSI-F-CM1 Interface Module Panel
The module panel includes two connectors:
• MANAGEMENT RS-232 connector, for connection to a supervision terminal.
• STATION CLK, for connection to an external (station) clock source. The station
clock is distributed to all the modules installed in LRS-24.
Interface Module Installation
➤ To install LRSI-F-CM1 Interface module:
1. Check that the POWER switch of the interface module is set to OFF.
2. Insert the LRSI-F-CM-1 module in the CL interface slot.
3. Fasten with the two screws.
LRSI-F-1-CM2 / LRSI-B-1-CM2 Interface Modules with 10BaseT
This section explains the installation of the 10BaseT Interface module for the CM-2
module: LRSI-F-1-CM2 or LRSI-FB-1-CM2.
LRSI-F-1-CM2 10BT / LRSI-B-1-CM2 Front Panel
A typical LRSI-F-1-CM2 or LRSI-B-1-CM2 module front panel, with 10BaseT, is
shown in Figure 2-10.
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com