RAD Data comm LRS-24 - Manual (Page 34)

Chapter 2 Installation and Setup LRS-24 Installation and Operation Manual
2-6 Installation and Setup
4. Check the packing list against your order to ensure that the supplied modules
match your order. If modules have been pre-installed in accordance with your
order, check that all modules are in their proper slots and are secure. Report
immediately any deviations.
5. Check that all necessary cables have been included.
2.4 Installation and Setup
This section describes how to perform the mechanical installation of the following
items:
• PS module
• CM-1 module
• CM-2 module.
PS Modules
This section covers the installation of the PS modules in an LRS-24 enclosure. For
installation of the associated PS interface modules, see Section 2.5. Obtain the
system installation plan before starting the installation.
Dangerous voltages are present inside the PS modules when connected to
power.
Do not connect a PS interface module to power before it is properly installed
within the LRS-24 enclosure. Disconnect the input power from the module
before removing it from the enclosure.
Two types of PS modules are currently available: PS-LRS/230/115, and PS-LRS/48.
Each module is also available with the /P option, which supports the supply of
remote feed voltage from an external source.
Front Panels
Typical front panels for PS modules are shown in Figure 2-3. Indicator functions
are listed in Table 2-1.
Warning
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com