D.8 defining card configuration, Purpose, Format – RAD Data comm LRS-24 User Manual

Page 121: Procedure

LRS-24 Installation and Operation Manual

Appendix D CM-2 Management Commands

Defining Card Configuration

D-19

D.8 Defining Card Configuration

Purpose

Defines card type, name, and connection to a remote modem.

Format

NODE 13 DEF CRD

Procedure

➤

To define card type, name, and connection:
• Type: NODE 13 DEF CRD .

Information about all the cards in the hub is displayed. A typical form is
shown in Figure D-18.

DEFINE CARD TYPE

Slot Type Modem Remote1 Remote2 Remote3 Remote4

Card 1 : EMPTY NULL LINKED

LINKED

Card 2 : EMPTY NULL LINKED

LINKED

Card 3 : IMODE ASMi-31CQ(m) LINKED

LINKED

Card 4 : EMPTY NULL LINKED

LINKED

Card 5 : EMPTY NULL LINKED

LINKED

Card 6 : EMPTY NULL LINKED

LINKED

Card 7 : EMPTY NULL LINKED

LINKED

Card 8 : IMODE FOMi-E1/T1C(m) LINKED

LINKED

Card 9 : IMODE ASMi-31C(m) LINKED

LINKED

Card 10 : IMODE ASMi-24C(m) LINKED

LINKED

Card 11 : IMODE ASMi-31C(m) LINKED

LINKED

Card 12 : IMODE ASMi-50C(m) LINKED

LINKED

Figure D-18. Define Card Type Screen

Each slot number shows the type of modem, name, and connection to a remote

modem.
For parameters Type and Modem:
• If Type is IMODE both fields are read-only.
• If Type is EMPTY you can define Type and Modem name, only when in

Terminal Mode.

• If Type is SMODE you can define Modem name.

Remote1 defines whether the modem is connected to (LINKED) or disconnected
from (UNLINKED) a remote modem. A double modem card, such as
FOMi-E1/T1CD, is defined for two remote modems - Remote1 and Remote2.

Order from: Cutter Networks

Ph:727-398-5252/Fax:727-397-9610