RAD Data comm LRS-24 - Manual (Page 45)

LRS-24 Installation and Operation Manual Chapter 2 Installation and Setup
Interfaces and Connections 2-17
LRSI-F-PSP/230/115
PHANTOM POWER
150V
LRSI-F-PS/48
PHANTOM
150V
48V
CHASS
GND
MAIN POWER SUPPLY
100-230VAC
CHASS
GND
CHASS
GND
+ _ + _
3A T 250V
CAUTION
THIS UNIT MAY HAVE MORE
THAN ONE POWER SUPPLY. TO
REDUCE THE RISK OF ELECTRIC
SHOCK DISCONNECT ALL
POWER SUPPLY CORDS BEFORE
SERVICING CAUTION
THIS UNIT MAY HAVE MORE
THAN ONE POWER SUPPLY. TO
REDUCE THE RISK OF ELECTRIC
SHOCK DISCONNECT ALL
POWER SUPPLY CORDS BEFORE
SERVICING
+ _
Figure 2-8. LRSI-F-PSP/230/114 and LRSI-F-PS/48 Interface Module Panels
Interface Module Installation
➤ To install the PS interface module:
1. Check that the POWER switch of the interface module is set to OFF.
2. Insert the specified type of module in the PS-A interface slot, referring to the
system installation plan, in LRS-24 Module Slots, Chapter 1.
3. Fasten with the two screws.
4. If an additional (redundant) PS module is used, install the corresponding
module in the PS-B interface slot.
LRSI-F-CM1
This section explains the installation of the interface module for the CM-1 module,
LRSI-F-CM1.
Interface Module Front Panel
A typical LRSI-F-CM1 module front panel is shown in Figure 2-9.
Order from: Cutter Networks Ph:727-398-5252/Fax:727-397-9610 www.bestdatasource.com