NEC MH4500 - Manual (Page 97)

Upgrading Your System 4-27
Note: A failed SCSI hard drive is indicated by a
continuously lit yellow LED on the front panel. The LEDs and
corresponding hard drives are numbered 0 through 5, from
top to bottom (for example, drive 0 is the top-most hard drive
in the bay and drive 5 is the bottom-most drive in the bay).
3. Press the rounded tab on the right of the carrier towards the center of the
drive (B in the following figure) while gently pulling down the carrier
handle (A in the figure).
B
A
Unlocking the Carrier
4. With the handle pulled down, pull the carrier and drive out of the bay.
5. Place the carrier and drive on an antistatic surface.
6. Install a replacement carrier and SCSI hard drive as previously described.
7. Close and lock (if appropriate) the metal door, and close the front panel.
Installing Removable Media Devices
Your system supports up to three SCSI removable media devices, including the
factory installed SCSI CD-ROM drive. The CD-ROM drive is shipped installed
in the bottom slot, with the remaining two slots available for installation of
optional devices (tape drive, other removable devices). Additional devices
should be installed in the first available slot from the top.
Your system ships with a four-connector narrow SCSI cable. The SCSI CD-
ROM drive is connected as the last device on the SCSI cable and is terminated.
Additional single-ended SCSI removable media devices can be connected to the
remaining connectors.
If you are adding or removing a SCSI removable media device, consider the
following:
T A tape drive SCSI address assignment is 2.