NEC MH4500 - Manual (Page 58)

3-14 Configuring Your System
Console Redirection Submenu
The following table lists the settings for the Console Redirection Submenu.
Console Redirection Submenu
Feature Choices Description Your Setting
COM Port Address Disabled
3F8
2F8
3E8 When enabled, console redirection
uses the I/O port specified. 3F8 is
typically COM 1 and 2F8 is typically
COM2.
IRQ # 3 or 4
None When console redirection is
enabled, this displays the IRQ
assigned per the address chosen in
the COM Port Address field.
Baud Rate 9600
19.2k
38.4k
115.2k Communications line dependent.
Flow Control No Flow Control
CTS/RTS
XON/XOFF
CTS/RTS + CD Communications line dependent.
Boot Menu
The following table lists the settings for the Boot Menu.
Boot Menu
Feature Choices Description Your Setting
Floppy Check Disabled
Enabled If enabled, system verifies diskette
type on boot. Disabled results in a
faster boot.
BIOS Boot Spec
Support Limited
Enabled Enable only if the total number of
hard drives is less than eight.
Boot Device Priority Press Enter. Refer to “Boot Device Priority
Submenu.”
Hard Drive Press Enter. Refer to “Hard Drive Submenu.”
Removable Devices Press Enter. Refer to “Removable Devices
Submenu.”
Maximum Number of
I20 drives 1
4 Selects maximum number of I20
drives assigned a DOS drive letter.
Message Timeout
Multiplier 1, 2, 8, 10, 50, 100,
1000 All timeout values are multiplied by
this number.
Boot Device Priority Submenu
The following table lists the settings for the Boot Device Priority Submenu. Use
the up or down arrow keys to select a device, then press the <+> or <-> keys to
move the device higher or lower in the boot priority list.