NEC MH4500 - Manual (Page 32)

2-12 Setting Up Your System
Converting the System Pedestal Unit
Converting your pedestal system to a rack mounted unit consists of:
T removing the top and side covers
T removing the bezel frame
T installing a new bezel frame
T installing handles
T attaching slide rails to the chassis
T preparing the rack.
After the system unit is converted to a rack unit, install the unit in the rack (see
“Installing the Unit in the Rack” later in this chapter).
Removing the System Unit Covers
Remove the one piece system unit top and side cover as follows.
1. Power down the system, disconnect any peripheral devices, and unplug all
power cords.
2. At the back of the system unit, remove and save the screw from the top
cover (see the following figure).
Removing the Cover Screws