NEC MH4500 - Manual (Page 40)

2-20 Setting Up Your System
1
2
3
2 2
5
6
4
4 6
7
2
2
1. Back Extension Bracket
2. 8-32 Screw
3. Flat Washer, Lock Washer, and 8-32 Nut
4. Large Outer Bar
5. Safety Latch on Center Bar
6. Center Bar
7. Front Extension Bracket
Installing the Slider Assembly
1. With the safety latch (5 on the above figure) end of the slider assembly
towards the back of the rack, press the flat side of the slider assembly into
the U-shaped sections of the previously installed extension
brackets (1 and 7).
2. Slide the slider assembly towards the front of the rack until the end of the
large outer bar (4) is flush with the end of the U-shaped section of the front
extension bracket (7).
3. Carefully slide the center bar (6) towards the front of the rack until the
oblong hole in the bar is over the first hole in the large outer bar (4).
T Insert a 8-32 screw through the oblong hole in the center bar, the hole in
the large outer bar, and into the first hole in the front extension bracket.
T Place a flat washer, lock washer, and a 8-32 nut on the screw and
loosely tighten.