NEC MH4500 - Manual (Page 95)

Upgrading Your System 4-25
Installing an Optional SCSI Hard Disk Drive
Install an optional SCSI hard disk drive as follows.
!
CAUTION
Observe static precautions. Use an antistatic wrist strap.
1. Turn off the system and disconnect all power cords from their power
sources.
2. Remove the 3 1/2-inch hard disk drive from its protective wrapper and place
the drive on an antistatic surface.
3. Record the drive model and serial number in the equipment log.
!
CAUTION
If the drive comes with drive rails, do not use them. Remove
any rails already attached.
4. Orient the drive and carrier as shown in the following figure.
Installing the Hard Drive Carrier
5. Secure the carrier to the drive with the four supplied screws.
6. Open the front panel on the server by grasping the right edge (as you face
the front) and swing the panel out.
7. Press in on the plastic latch securing the metal door and open the door.
T If the door is locked with a padlock, remove it.