NEC MH4500 - Manual (Page 51)

Configuring Your System 3-7
Advanced Menu
Feature Choices Description Your Setting
Use Multiprocessor
Specification 1.1
1.4 Selects version of multiprocessor
specification to use. Some
operating systems require version
1.1 for compatibility reasons.
Large Disk Access
Mode LBA
CHS Select LBA for IDE drives.
System Wakeup
Feature Disabled
Enabled If enabled, the system powers up
upon receiving a “magic packet” on
LAN, ring on COM2, or PME
interrupt from a PCI board.
Pause Before Boot Enabled
Disabled Enables five second delay before
booting operating system.
Advanced Chipset
Control Press Enter Refer to “Advanced Chipset Control
Submenu.”
PCI Configuration Submenus
The following tables show the settings for the PCI Device Embedded SCSI
submenu and PCI Devices submenu. The submenus should only be changed by
qualified technical personnel.
!
CAUTION
Leave the PCI Device Embedded SCSI submenu at factory-
default settings. This submenu should only be changed by
qualified technical personnel.
PCI Device, Embedded SCSI Submenu
Feature Choices Description Your Setting
Option ROM Scan Enabled
Disabled Enables option ROM scan of the
selected device. Used to enable
embedded Symbios SCSI
controller
Enable Master Enabled
Disabled Enabled selects the device as a
PCI bus master.
Latency Timer Default
0020h
0040h
0060h
0080h
00A0h
00C0h
00E0h Minimum guaranteed time, in units
of PCI bus clocks, that a device
may be master on a PCI bus.
Caution: Do not change this setting
unless you fully understand the
priority of this device on the PCI
bus.
Active Termination Disabled
SCSI A On Selects the setting of the onboard