NETGEAR 7300 Series - Manual (Page 99)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands 8-33
202-10009-01_060204
snmp-server enable traps multiusers
This command enables Multiple User traps. When the traps are enabled, a Multiple User Trap is
sent when a user logs in to the terminal interface (EIA 232 or telnet) and there is an existing
terminal interface session.
Default
Enabled
Format snmp-server enable traps multiusers
Mode
Global Config
no snmp-server enable traps multiusers
This command disables Multiple User traps.
Format no snmp-server enable traps multiusers
Mode
Global Config
snmp-server enable traps stpmode
This command enables the sending of new root traps and topology change notification traps.
Default Enabled
Format snmp-server enable traps stpmode
Mode Global Config
no snmp-server enable traps stpmode
This command disables the sending of new root traps and topology change notification traps.
Format
no snmp-server enable traps stpmode
Mode Global Config
snmptrap
This command adds an SNMP trap name. The maximum length of name is 16 case-sensitive
alphanumeric characters.
Default The default name for the six undefined community names is
Delete.
Format
snmptrap <name>