NETGEAR 7300 Series - Manual (Page 136)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-70 Switching Commands
202-10009-01_060204
Format
no switchconfig storm-control broadcast
Mode Global Config
storm-control flowcontrol
This command enables 802.3x flow control for the switch.
Note: This command only applies to full-duplex mode ports.
Default
Disabled
Format storm-control flowcontrol
Mode
Global Config
no storm-control flowcontrol
This command disables 802.3x flow control for the switch.
Note: This command only applies to full-duplex mode ports.
Format
no storm-control flowcontrol
Mode Global Config
vlan
This command creates a new VLAN and assigns it an ID. The ID is a valid VLAN identification
number (ID 1 is reserved for the default VLAN). VLAN range is 2-4094.
Format vlan <2-4094>
Mode
VLAN database
Table 8-2. Broadcast Storm Recovery Thresholds
Link Speed High Low
10M 20 10
100M 5 2
1000M 5 2