NETGEAR 7300 Series - Manual (Page 145)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands 8-79
202-10009-01_060204
show spanning-tree interface
This command displays the settings and parameters for a specific switch port within the common
and internal spanning tree. The is the desired switch port. The following details are
displayed on execution of the command.
Format show spanning-tree interface
Mode Privileged EXEC and User EXEC
Port mode Enabled or disabled .
Port Up Time Since Counters Last Cleared Time since port was reset, displayed in
days, hours, minutes, and seconds.
STP BPDUs Transmitted Spanning Tree Protocol Bridge Protocol Data Units sent
STP BPDUs Received Spanning Tree Protocol Bridge Protocol Data Units received.
RST BPDUs Transmitted Rapid Spanning Tree Protocol Bridge Protocol Data Units sent
RST BPDUs Received Rapid Spanning Tree Protocol Bridge Protocol Data Units
received.
MSTP BPDUs Transmitted Multiple Spanning Tree Protocol Bridge Protocol Data Units
sent
MSTP BPDUs Received Multiple Spanning Tree Protocol Bridge Protocol Data Units
received.
show spanning-tree mst detailed
This command displays settings and parameters for the specified multiple spanning tree instance.
The instance is a number that corresponds to the desired existing multiple spanning tree
instance ID. The following details are displayed.
Format show spanning-tree mst detailed
Mode Privileged EXEC and User EXEC
MST Instance ID
MST Bridge Priority
Time Since Topology Change in seconds
Topology Change Count Number of times the topology has changed for this multiple
spanning tree instance.
Topology Change in Progress Value of the Topology Change parameter for the multiple
spanning tree instance