NETGEAR 7300 Series - Manual (Page 198)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-16 Routing Commands
202-10009-01_060204
Format
no default-metric
Mode Router RIP Config
enable (OSPF)
This command resets the default administrative mode of OSPF in the router (active).
Default Enabled
Format enable
Mode
Router OSPF Config
no enable (OSPF)
This command sets the administrative mode of OSPF in the router to inactive.
Format
no enable
Mode Router OSPF Config
enable (RIP)
This command resets the default administrative mode of RIP in the router (active).
Default Enabled
Format enable
Mode
Router RIP Config
no enable (RIP)
This command sets the administrative mode of RIP in the router to inactive.
Format no enable
Mode
Router RIP Config
distance ospf
This command sets the route preference value of OSPF in the router. Lower route preference
values are preferred when determining the best route. The type of OSPF can be intra, inter, type-1,
or type-2. The OSPF specification (RFC 2328) requires that preferences must be given to the
routes learned via OSPF in the following order: intra < inter < type-1 < type-2.