NETGEAR 7300 Series - Manual (Page 107)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands 8-41
202-10009-01_060204
monitor session mode
This command configures the monitor session (port monitoring) mode to enable. The probe and
monitored ports must be configured before monitor session (port monitoring) can be enabled. If
enabled, the probe port will monitor all traffic received and transmitted on the physical monitored
port. It is not necessary to disable port monitoring before modifying the probe and monitored
ports.
Default Disabled
Format
monitor session mode
Mode Global Config
no monitor session mode
This command sets the monitor session (port monitoring) mode to disable.
Format
no monitor session mode
Mode Global Config
port lacpmode
This command enables Link Aggregation Control Protocol (LACP) on a port.
Default
Disabled
Format port lacpmode
Mode
Interface Config
no port lacpmode
This command disables Link Aggregation Control Protocol (LACP) on a port.
Format no port lacpmode
Mode
Interface Config
port lacpmode all
This command enables Link Aggregation Control Protocol (LACP) on all ports.
Format port lacpmode all
Mode
Global Config