NETGEAR 7300 Series - Manual (Page 143)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands 8-77
202-10009-01_060204
no vlan pvid
This command sets the VLAN ID per interface to 1.
Format no vlan pvid <1-4094>
Mode Interface Config
vlan tagging
This command configures the tagging behavior for a specific interface in a VLAN to enabled. If
tagging is enabled, traffic is transmitted as tagged frames. If tagging is disabled, traffic is
transmitted as untagged frames. The ID is a valid VLAN identification number.
Format vlan tagging <1-4094>
Mode
Interface Config
no vlan tagging
This command configures the tagging behavior for a specific interface in a VLAN to disabled. If
tagging is disabled, traffic is transmitted as untagged frames. The ID is a valid VLAN
identification number.
Format
no vlan tagging <1-4094>
Mode Interface Config
Spanning Tree Commands
This section provides detailed explanation of the spanning tree commands. The commands are
divided into two functional groups:
• Show commands display spanning tree settings, statistics, and other information.
• Configuration Commands configure features and options of the switch. For every
configuration command there is a show command that displays the configuration setting.
show spanning-tree
This command displays spanning tree settings for the common and internal spanning tree, when
the optional parameter “brief” is not included in the command. The following details are
displayed.