Network, No network, Service dhcp – NETGEAR 7300 Series User Manual
Page 278: No service dhcp, Dhcp server show commands, Network -6, No network -6, Service dhcp -6, No service dhcp -6, Dhcp server show commands -6
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
12-6
DHCP Server Commands
202-10009-01_060204
network
This command is used to configure the subnet number and mask for a DHCP address pool on the
server. Network-number is a valid IP address, made up of four decimal bytes ranging from 0 to
255. IP address 0.0.0.0 is invalid. Mask is the IP subnet mask for the specified address pool. The
prefix-length is an integer from 0 to 32.
Default
None
Format
network
Mode
DHCP Pool Config
no network
This command removes the subnet number and mask.
Format
no network
Mode
DHCP Pool Config
service dhcp
This command enables the DHCP server and relay agent features on the router.
Default
Disabled
Format
service dhcp
Mode
Global Config
no service dhcp
This command disables the DHCP server and relay agent features.
Format
no service dhcp
Mode
Global Config
DHCP Server Show Commands
These commands display the DHCP Server address bindings, and statistics.