NETGEAR 7300 Series - Manual (Page 160)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
8-94 Switching Commands
202-10009-01_060204
users snmpv3 authentication
This command specifies the authentication protocol to be used for the specified login user. The
valid authentication protocols are
none , md5 or sha . If md5 or sha are specified, the user login
password will be used as the snmpv3 authentication password. The < username> is the login user
name for which the specified authentication protocol will be used.
Default no authentication
Format
users snmpv3 authentication {none | md5 |
sha}
Mode Global Config
no users snmpv3 authentication
This command sets the authentication protocol to be used for the specified login user to none. The
is the login user name for which the specified authentication protocol will be used.
Format users snmpv3 authentication
Mode Global Config
users snmpv3 encryption
This command specifies the encryption protocol and key to be used for the specified login user.
The valid encryption protocols are
none or des . The des protocol requires a key , which can be
specified on the command line. The key may be up to 16 characters long. If the des protocol is
specified but a key is not provided, the user will be prompted for the key. If none is specified, a key
must not be provided. The < username> is the login user name for which the specified encryption
protocol will be used.
Default no encryption
Format users snmpv3 encryption {none | des [key]}
Mode Global Config
no users snmpv3 encryption
This command sets the encryption protocol to none. The is the login user name for
which the specified encryption protocol will be used.
Format no users snmpv3 encryption
Mode Global Config