NETGEAR 7300 Series - Manual (Page 196)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-14 Routing Commands
202-10009-01_060204
bootpdhcprelay serverip
This command configures the server IP Address for BootP/DHCP Relay on the system. The
parameter is an IP address in a 4-digit dotted decimal format.
Default 0.0.0.0
Format bootpdhcprelay serverip
Mode
Global Config
no bootpdhcprelay serverip
This command configures the default server IP Address for BootP/DHCP Relay on the system.
Format no bootpdhcprelay serverip
Mode
Global Config
clear arp-cache
This command causes all ARP entries of type dynamic to be removed from the ARP cache. If the
gateway parameter is specified, the dynamic entries of type gateway are purged as well.
Format
clear arp-cache [gateway]
Mode Privileged Exec
default-information originate (OSPF)
This command is used to control the advertisement of default routes.
Default value for metric unspecified
Default value for type 2
Format
default-information originate [always] [metric <0-
16777215>] [metric-type {1 | 2}]
Mode Router OSPF Config
no default-information originate (OSPF)
This command is used to control the advertisement of default routes.
Format
no default-information originate [metric] [metric-
type]