NETGEAR 7300 Series - Manual (Page 224)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-42 Routing Commands
202-10009-01_060204
show ip ospf database
This command displays the link state database. This command takes no options. The information
below will only be displayed if OSPF is enabled.
Format show ip ospf database
Mode
Privileged EXEC and User EXEC
Router ID Is a 32 bit dotted decimal number representing the LSDB inter-
face.
Area ID Is the IP address identifying the router ID.
LSA Type The types are: router, network, ipnet sum, asbr sum, as external,
group member, tmp 1, tmp 2, opaque link, opaque area.
LS ID Is a number that "uniquely identifies an LSA that a router origi-
nates from all other self originated LSA's of the same LS type."
Age Is a number representing the age of the link state advertisement in
seconds.
Sequence Is a number that represents which LSA is more recent.
Checksum Is to total number LSA checksum.
Options This is an integer. It indicates that the LSA receives special han-
dling during routing calculations.
show ip ospf interface
This command displays the information for the IFO object or virtual interface tables.
Format
show ip ospf interface <slot/port>
Mode Privileged EXEC and User EXEC
IP Address Represents the IP address for the specified interface. This is a
configured value.
Subnet Mask Is a mask of the network and host portion of the IP address for the
OSPF interface. This value was configured into the unit. This is a
configured value.
OSPF Admin Mode States whether OSPF is enabled or disabled on a router interface.
This is a configured value.
OSPF Area ID Represents the OSPF Area Id for the specified interface. This is a
configured value.