NETGEAR 7300 Series - Manual (Page 276)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
12-4 DHCP Server Commands
202-10009-01_060204
ip dhcp excluded-address
This command specifies the IP addresses that a DHCP server should not assign to DHCP clients.
Low-address and high-address are valid IP addresses; each made up of four decimal bytes ranging
from 0 to 255. IP address 0.0.0.0 is invalid.
Default None
Format ip dhcp excluded-address [highaddress]
Mode Global Config
no ip dhcp excluded-address
This command removes the excluded IP addresses for a DHCP client.
Low-address and high-address are valid IP addresses; each made up of four decimal bytes ranging
from 0 to 255. IP address 0.0.0.0 is invalid.
Format no ip dhcp excluded-address [highad-
dress]
Mode Global Config
ip dhcp ping packets
This command is used to specify the number in a range from 2-10, of packets a DHCP server sends
to a pool address as part of a ping operation. Setting the number of ping packets to 0 is the same as
‘no ip dhcp ping packets’ and will prevent the server from pinging pool addresses.
Default 2
Format ip dhcp ping packets <0,2-10>
Mode Global Config
no ip dhcp ping packets
This command prevents the server from pinging pool addresses and will set the number of packets
to 0.
Default 0
Format no ip dhcp ping packets
Mode Global Config