NETGEAR 7300 Series - Manual (Page 190)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
9-8 Routing Commands
202-10009-01_060204
Mode
Router OSPF Config
no area virtual-link retransmit-interval
This command configures the default retransmit interval for the OSPF virtual interface on the
virtual interface identified by and . The parameter is the IP
address of the neighbor.
Format
no area <areaid> virtual-link retransmit-
interval
Mode
Router OSPF Config
area virtual-link transmit-delay
This command configures the transmit delay for the OSPF virtual interface on the virtual interface
identified by and . The parameter is the IP address of the
neighbor. The range for is 0 to 3600 (1 hour).
Default 1
Format
area <areaid> virtual-link transmit-delay
<0-3600>
Mode
Router OSPF Config
no area virtual-link transmit-delay
This command configures the default transmit delay for the OSPF virtual interface on the virtual
interface identified by and . The parameter is the IP address of
the neighbor.
Format
no area <areaid> virtual-link transmit-
delay
Mode
Router OSPF Config
arp
This command creates an ARP entry. The value for is the IP address of a device on a
subnet attached to an existing routing interface. is a unicast MAC address for that
device.