NETGEAR 7300 Series - Manual (Page 163)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands 8-97
202-10009-01_060204
dot1x login
This command assigns the specified authentication login list to the specified user for 802.1x port
security. The parameter must be a configured user and the parameter must be a
configured authentication login list.
Format dot1x login
Mode Global Config
dot1x max-req
This command sets the maximum number of times the authenticator state machine on this port will
transmit an EAPOL EAP Request/Identity frame before timing out the supplicant. The
value must be in the range 1 - 10.
Default 2
Format dot1x max-req
Mode
Interface Config
no dot1x max-req
This command sets the maximum number of times the authenticator state machine on this port will
transmit an EAPOL EAP Request/Identity frame before timing out the supplicant to the default
value, i.e. 2.
Format no dot1x max-req
Mode Interface Config
dot1x port-control
This command sets the authentication mode to be used on the specified port. . The control mode
may be one of the following.
• force-unauthorized: The authenticator PAE unconditionally sets the controlled port to
unauthorized.
• force-authorized: The authenticator PAE unconditionally sets the controlled port to
authorized.
• auto: The authenticator PAE sets the controlled port mode to reflect the outcome of the
authentication exchanges between the supplicant, authenticator and the authentication server.