NETGEAR 7300 Series - Manual (Page 213)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Routing Commands 9-31
202-10009-01_060204
ip route
This command configures a static route. The and are valid ip
addresses. The is a valid subnet mask. The [metric] parameter is an integer value
from 0 to 255. The default value is 1.
Format
ip route <networkaddr> [met-
ric]
Mode Global Config
no ip route
This command causes a static route to be deleted. The and are valid
IP address. The is a 4-digit dotted-decimal number representing a valid Subnet
Mask.
Format
no ip route <networkaddr>
ip route default
This command configures the default route. The value for is a valid IP address of the
next hop router.
Format ip route default <nexthopip>
Mode
Global Config
no ip route default
This command causes the static default route to be deleted.
Format no ip route default
Mode
Global Config
ip route distance
This command sets the static route preference value in the router. Lower route preference values
are preferred when determining the best route.
Default 60
Format ip route distance <1-255>