NETGEAR 7300 Series - Manual (Page 119)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands 8-53
202-10009-01_060204
set igmp maxresponse
This command sets the IGMP Maximum Response time on the system. The Maximum Response
time is the amount of time in seconds that a switch will wait after sending a query on an interface
because it did not receive a report for a particular group in that interface. This value must be less
than the IGMP Query Interval time value. The range is 1 to 3600 seconds.
Default 10 seconds
Format set igmp maxresponse <1-3600>
Mode
Global Config
no set igmp maxresponse
This command sets the IGMP Maximum Response time on the system to 10 seconds.
Format no set igmp maxresponse
Mode
Global Config
set igmp mcrtrexpiretime
This command sets the Multicast Router Present Expiration time on the system. This is the amount
of time in seconds that a switch will wait for a query to be received on an interface before the
interface is removed from the list of interfaces with multicast routers attached. The range is 0 to
3600 seconds. A value of 0 indicates an infinite timeout, i.e. no expiration.
Default 0
Format
set igmp mcrtexpiretime <0-3600>
Mode Global Config
no set igmp mcrtrexpiretime
This command sets the Multicast Router Present Expiration time on the system to 0. A value of 0
indicates an infinite timeout, i.e. no expiration.
Format no set igmp mcrtexpiretime
Mode
Global Config
s how garp
This command displays Generic Attributes Registration Protocol (GARP) information.