Hardware-address, No hardware-address, Host – NETGEAR 7300 Series User Manual
Page 275: No host, Hardware-address -3, No hardware-address -3, Host -3, No host -3
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
DHCP Server Commands
12-3
202-10009-01_060204
hardware-address
This command specifies the hardware address of a DHCP client.
Hardware-address is the MAC address of the hardware platform of the client consisting of 6 bytes
in dotted hexadecimal format.
Type indicates the protocol of the hardware platform. It is 1 for 10 MB Ethernet and 6 for IEEE
802.
Default
Ethernet
Format
hardware-address
Mode
DHCP Pool Config Mode
no hardware-address
This command removes the hardware address of the DHCP client.
Format
no hardware-address
Mode
DHCP Pool Config Mode
host
This command specifies the IP address and network mask for a manual binding to a DHCP client.
Address and Mask are valid IP addresses; each made up of four decimal bytes ranging from 0 to
255. IP address 0.0.0.0 is invalid.
The prefix-length is an integer from 0 to 32
Default
None
Format
host [mask | prefix-length]
Mode
DHCP Pool Config Mode
no host
This command removes the IP address of the DHCP client.
Format
no host
Mode
DHCP Pool Config Mode