NETGEAR 7300 Series - Manual (Page 189)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Routing Commands 9-7
202-10009-01_060204
no area virtual-link dead-interval
This command configures the default dead interval for the OSPF virtual interface on the virtual
interface identified by and . The parameter is the IP address of
the neighbor.
Format
no area <areaid> virtual-link dead-inter-
val
Mode
Router OSPF Config
area virtual-link hello-interval
This command configures the hello interval for the OSPF virtual interface on the virtual interface
identified by and . The parameter is the IP address of the
neighbor. The range for is 1 to 65535.
Default 10
Format
area <areaid> virtual-link hello-interval
<1-65535>
Mode
Router OSPF Config
no area virtual-link hello-interval
This command configures the default hello interval for the OSPF virtual interface on the virtual
interface identified by and . The parameter is the IP address of
the neighbor.
Format
no area <areaid> virtual-link hello-inter-
val
Mode Router OSPF Config
area virtual-link retransmit-interval
This command configures the retransmit interval for the OSPF virtual interface on the virtual
interface identified by and . The parameter is the IP address of
the neighbor. The range for is 0 to 3600.
Default 5
Format
area <areaid> virtual-link retransmit-
interval <0-3600>