Network protocol, Remotecon maxsessions, No remotecon maxsessions – NETGEAR 7300 Series User Manual
Page 87: Network protocol -21, Remotecon maxsessions -21, No remotecon maxsessions -21
User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands
8-21
202-10009-01_060204
Mode
Privileged EXEC
network protocol
This command specifies the network configuration protocol to be used. If you modify this value
change is effective immediately.
Default
None
Format
network protocol {none | bootp | dhcp},
where
bootp
indicates that the switch periodically sends requests to a Boot-
strap Protocol (BootP) server or a dhcp server until a response is
received.
none
indicates that the switch should be manually con-
figured with IP information.
Mode
Privileged EXEC
remotecon maxsessions
This command specifies the maximum number of remote connection sessions that can be
established. A value of 0 indicates that no remote connection can be established. The range is 0 to
5.
Default
5
Format
remotecon maxsessions <0-5>
Mode
Privileged EXEC
no remotecon maxsessions
This command sets the maximum number of remote connection sessions that can be established to
the default value.
Default
5
Format
no remotecon maxsessions
Mode
Privileged EXEC