NETGEAR 7300 Series - Manual (Page 153)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Switching Commands 8-87
202-10009-01_060204
no spanning-tree max-age
This command sets the Bridge Max Age parameter for the common and internal spanning tree to
the default value, i.e. 20.
Format no spanning-tree max-age
Mode Global Config
spanning-tree mst
This command sets the Path Cost or Port Priority for this port within the multiple spanning tree
instance or in the common and internal spanning tree. If the parameter corresponds to an
existing multiple spanning tree instance, then the configurations are done for that multiple
spanning tree instance. If however 0 (defined as the default CIST ID) is passed as the ,
then the configurations are performed for the common and internal spanning tree instance.
If the ‘cost’ token is specified, this command sets the path cost for this port within a multiple
spanning tree instance or the common and internal spanning tree instance, depending on the
parameter. The pathcost can be specified as a number in the range of 1 to 200000000 or
auto. If "auto" is specified, the pathcost value will be set based on Link Speed.
If the ‘port-priority’ token is specified, this command sets the priority for this port within a specific
multiple spanning tree instance or the common and internal spanning tree instance, depending on
the parameter. The port-priority value is a number in the range of 0 to 240 in increments
of 16.
Default cost: auto
port-priorty 128
Format spanning-tree mst {cost {<1-200000000> | auto} | port-
priority <0-240>}
Mode Interface Config
no spanning-tree mst
This command sets the Path Cost or Port Priority for this port within the multiple spanning tree
instance or in the common and internal spanning tree to the respective default values. If the
parameter corresponds to an existing multiple spanning tree instance, then the
configurations are done for that multiple spanning tree instance. If however 0 (defined as the
default CIST ID) is passed as the , then the configurations are performed for the common
and internal spanning tree instance.