NETGEAR 7300 Series - Manual (Page 197)

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Routing Commands 9-15
202-10009-01_060204
Mode
Router OSPF Config
default-information originate (RIP)
This command is used to control the advertisement of default routes.
Format default-information originate
Mode
Router RIP Config
no default-information originate (RIP)
This command is used to control the advertisement of default routes.
Format no default-information originate
Mode
Router RIP Config
default-metric (OSPF)
This command is used to set a default for the metric of distributed routes.
Format
default-metric <1-16777215>
Mode Router OSPF Config
no default-metric (OSPF)
This command is used to set a default for the metric of distributed routes.
Format
no default-metric
Mode Router OSPF Config
default-metric (RIP)
This command is used to set a default for the metric of distributed routes.
Format
default-metric <0-15>
Mode Router RIP Config
no default-metric (RIP)
This command is used to reset the default metric of distributed routes to its default value.