Nortel Networks Circuit Card - Manual (Page 532)

Page 532 of 906 NT8D02 and NTDK16 Digital Line cards
553-3001-211 Standard 3.00 August 2005
NTDK16 Digital Line card
The NTDK16 digital line card is equipped with 48 identical units. Each unit
provides a multiplexed voice, data, and signaling path to and from digital
apparatus over a 2-wire full duplex 512 kHz time compression multiplexed
(TCM) digital link. Each digital telephone and associated data terminal is
assigned a separate terminal number (TN) in the system database, for a total
of 96 addressable ports per card. Refer to Figure 106 on
page 533 .
The NTDK16 digital line card contains a microprocessor that provides the
following functions:
• self-identification
• self-test
• control of card operation
• status report to the controller
• maintenance diagnostics
The card also provides:
• Ability to support Digital sets and the Digital Console M2250
• Provides a serial link (Card LAN) for status report and maintenance.
• Supports loop lengths up to 3500 ft. (1.0 km) using 24 AWG wire.
• Interface between three DS30X loops and 48 TCM lines.
Card interfaces
The digital line card passes voice, data, and signaling over DS-30X loops and
maintenance data over the card LAN link. These interfaces are discussed in
detail in the section “Intelligent Peripheral Equipment” on
page 32 .
Digital line interfaces
The digital line interface contains two Digital Line Interface Circuits (DLIC).
Each digital line interface circuit provides eight identical, individually
configurable voice and data interfaces to eight digital telephone lines. These