Nortel Networks NN46120-104 User Manual
Page 77
Activating the Software Upgrade Package
77
>> Software Management# activate 7.0.1
Confirm action ’activate’?
[y/n]: y
Activate ok, relogin
here>
Restarting system.
login:
Note: Activating the unpacked software upgrade package
may cause the command line interface (CLI) software to be
upgraded as well. Therefore, you will be logged out of the
system, and will have to log in again. Wait until the
login
prompt appears. This may take up to 2 minutes, depending
on your type of hardware platform and whether the system
reboots.
3
After having logged in again, verify the new software
version:
>> Main# boot/software/cur
Version
Name
Status
-------
----
------
7.0.1
SSL
permanent
5.1.5
SSL
old
In this example, version 7.0.1 is now operational and will survive
a reboot of the system, while the software version previously
indicated as permanent is marked as old.
Note: If you encounter serious problems while running the
new software version, you can revert to the previous software
version (now indicated as old). To do this, activate the
software version indicated as old. When you log in again
after having activated the old software version, its status is
indicated as current for a short while. After about one minute,
when the system has performed the necessary health checks,
the current status is changed to permanent.
--End--
Nortel VPN Gateway
User Guide
NN46120-104
02.01
Standard
14 April 2008
Copyright © 2007-2008 Nortel Networks
.