Complete the join setup – Nortel Networks NN46120-104 User Manual
Page 56
56
Initial Setup
8
If a connected router or switch attaches VLAN tag IDs to
incoming packets, specify the VLAN tag ID used.
Enter VLAN tag id (or zero for no VLAN) [0]:
9
Enter the Management IP address (MIP) of the existing
cluster.
The system is initialized by connecting to the
management server on an existing iSD, which must be
operational and initialized.
Enter the Management IP (MIP) address:
Provide the Management IP address of the cluster to which
you want to join the current VPN Gateway. To check the
Management IP of an existing cluster, connect to the cluster and
use the
/cfg/sys/cur
command.
10
Enter the default gateway on the traffic interface.
Enter default gateway IP address (on the traffic
interface):
The default gateway IP address should be within the same
network address range as the host IP address on the traffic
interface.
Complete the
join
setup by following the instructions in the next
section, "Complete the Join Setup".
--End--
Complete the Join Setup
Step
Action
1
Provide the correct admin user password.
Type the correct password for the admin user.
(
join
setup, continued)
Enter the existing admin user password:
2
Specify the VPN Gateway type.
When adding up to three additional master NVGs to a cluster
containing a single VPN Gateway, you may configure each
additional NVG as either master or slave. For up to three
additional NVGs, the default setting is master. When adding one
Nortel VPN Gateway
User Guide
NN46120-104
02.01
Standard
14 April 2008
Copyright © 2007-2008 Nortel Networks
.