Nortel Networks NN46120-104 User Manual

Page 101

Copy-and-Paste Certificates

101

Paste the contents of the certificate file at the command
prompt.

Now, paste the certificate at the command line interface prompt,
press ENTER to create a new empty line, and then type " ... "
(without the quotation marks). Press ENTER again to complete
the installation of the certificate.

Your screen output should now resemble the following example:

Note: Depending on the type of certificate the CA generates
(registered or chain), your certificate may appear substantially
different from the one shown before. Be sure to copy and
paste the entire contents of the certificate file.

Apply your changes.

>> Certificate 1# apply

Changes applied successfully.

If you have used the request command on the VPN Gateway to
generate a CSR, and have specified the same certificate number
as the CSR when pasting the contents of the certificate file, your
certificate is now fully installed.

Nortel VPN Gateway

User Guide

NN46120-104

02.01

Standard

14 April 2008