Nortel Networks NN46120-104 - Manual (Page 105)

Using TFTP/FTP/SCP/SFTP to add Certificates and Keys 105
FTP User (anonymous):
anonymous mode>
Password:
password in anonymous mode>
received 2392 bytes
Enter pass phrase:
Provided the operation was successful and the certificate file
includes your private key, your screen output should resemble
the following example:
Key added.
Certificate added.
Use ’apply’ to activate changes.
5 Add your private key (if in a separate file).
This step is only required if the certificate file does not include
the private key. You may be prompted for a password phrase (if
specified when creating or exporting the private key).
>> Certificate 1# import
Select protocol (tftp/ftp/scp/sftp) [tftp]: ftp
Enter host name or IP address of server:
name or IP address>
Enter filename on server:
Retrieving VIP_1.key from 192.168.128.58 FTP User
(anonymous):
mode>
Password:
password in anonymous mode>
received 392 bytes
Enter pass phrase:
Key added.
Use ’apply’ to activate changes.
6 Apply your changes.
>> Certificate 1# apply
Changes applied successfully.
If the NVG software is used for SSL acceleration purposes, the
certificate should be mapped to the virtual SSL server, using the
/cfg/ssl/server #/ssl/cert command.
If the NVG software is used for deployment of a VPN solution,
the certificate should be mapped to the portal server of the
Nortel VPN Gateway
User Guide
NN46120-104 02.01 Standard
14 April 2008
Copyright © 2007-2008 Nortel Networks
.