beautypg.com

Nortel Networks NN46120-104 User Manual

Page 43

background image

Setting Up a One-Armed Configuration

43

You can later use the

/cfg/sys/host 1/interface 1

command to view the resulting settings for Interface 1.

Note: If needed, you can later create a two-armed
configuration by adding a new interface to the cluster,
exclusively used for client traffic, and assign an unused port
to that interface. For information about how to add a new
interface, see the "Interface Configuration " section under
Configuration Menu>System Configuration in the Command
Reference
. For information about how to assign ports to an
interface, see the "Interface Ports Configuration " section in
the same chapter.

4

Enter network mask and VLAN tag ID.

Enter network mask [255.255.255.0]:

correct>

Enter VLAN tag id (or zero for no VLAN) [0]:

id or ENTER>

Specify the desired network mask or accept the suggested value
by pressing ENTER. If a connected router or switch attaches
VLAN tag IDs to incoming packets, specify the VLAN tag ID
used.

5

Press ENTER to continue with creating a one-armed
configuration.

Setup a two armed configuration (yes/no) [no]:

ENTER>

6

Enter a default gateway address.

Enter default gateway IP address (or blank to skip):

Enter a default gateway IP address that is within the same
network address range as the host IP address configured in step
3.

7

Enter a Management IP address (MIP).

Enter a unique Management IP address (MIP) that is within the
same network address range as the host IP address and the
default gateway IP address.

Enter the Management IP (MIP) address:

Making sure the MIP does not exist...ok

Trying to contact gateway...ok

Nortel VPN Gateway

User Guide

NN46120-104

02.01

Standard

14 April 2008

Copyright © 2007-2008 Nortel Networks

.