Nortel Networks NN46120-104 User Manual
Page 53
Setting up a One-Armed Configuration
53
[Setup Menu]
join
- Join an existing iSD cluster
new
- Initialize iSD as a new installation
boot
- Boot menu
info
- Information menu
exit
- Exit
[global command, always
available]
>> Setup# join
Setup will guide you through the initial configuration
of the iSD.
2
Specify the port to be used for network connectivity.
Enter port number for the management interface [1-4]: 1
This port will automatically be assigned to Interface 1. As you
are currently configuring a one-armed configuration, this interface
will be used for both management traffic (coming from the private
intranet) and client traffic (coming from the public Internet).
If you have configured port 1 as the management interface port
for existing VPN Gateways, it is recommended (for consistency)
that you configure port 1 for the NVG you are joining as well.
3
Enter the VPN Gateway ’s host IP address.
Enter IP address for this machine (on management
interface):
This IP address should be within the same network address
range as the cluster’s Management IP address.
4
Enter network mask and VLAN tag ID.
Enter network mask [255.255.255.0]:
correct>
Enter VLAN tag id (or zero for no VLAN) [0]:
id or ENTER>
Specify the desired network mask or accept the suggested value
by pressing ENTER. If a connected router or switch attaches
VLAN tag IDs to incoming packets, specify the VLAN tag ID
used.
5
Press ENTER to continue with creating a one-armed
configuration.
Setup a two armed configuration (yes/no) [no]:
ENTER>
Nortel VPN Gateway
User Guide
NN46120-104
02.01
Standard
14 April 2008
Copyright © 2007-2008 Nortel Networks
.