Nortel Networks NN46120-104 - Manual (Page 55)

Setting up a Two-Armed Configuration 55
Specify the port you want to use for management traffic. This
port will be assigned to an interface for management purposes
only (Interface 1).
3 Specify a host IP address on the management interface for
the current VPN Gateway.
Enter IP address for this machine (on management
interface):
This IP address must be unique on the network and be within
the same network address range as the Management IP address
(see
Step 9 ). The management interface host IP address will be
assigned to Interface 1.
4 Enter network mask and VLAN tag ID.
Enter network mask [255.255.255.0]:
correct>
Enter VLAN tag id (or zero for no VLAN) [0]:
id or ENTER>
Specify the desired network mask for the host IP address on
the management interface or accept the suggested value by
pressing ENTER. If a connected router or switch attaches VLAN
tag IDs to incoming packets, specify the VLAN tag ID used.
5 Enter yes and press ENTER to continue with creating a
two-armed configuration.
Setup a two armed configuration (yes/no) [no]: yes
6 Specify a new port number for the traffic interface.
Enter port number for the traffic interface [1-4]: 2
The traffic interface port number will automatically be assigned
to Interface 2.
7 Specify a host IP address and network mask on the traffic
interface for the current VPN Gateway.
Enter IP address for this machine (on traffic
interface):
Enter network mask [255.255.255.0]:
accepts>
In a two-armed configuration, the traffic interface host IP address
will be assigned to Interface 2.
Nortel VPN Gateway
User Guide
NN46120-104 02.01 Standard
14 April 2008
Copyright © 2007-2008 Nortel Networks
.