beautypg.com

Setting up a two-armed configuration – Nortel Networks NN46120-104 User Manual

Page 54

background image

54

Initial Setup

6

Enter the Management IP address (MIP) of the existing
cluster.

The system is initialized by connecting to the

management server

on an existing iSD, which must be operational and

initialized.

Enter the Management IP (MIP) address:

Provide the Management IP address of the cluster to which
you want to join the current VPN Gateway. To check the
Management IP of an existing cluster, connect to the cluster and
use the

/cfg/sys/cur

command.

Complete the

join

setup by following the instructions in the

section

“Complete the Join Setup” (page 56)

.

--End--

Setting up a Two-Armed Configuration

If the currently installed VPN Gateway(s) in the cluster are set up for a
two-armed configuration you probably want the new VPN Gateway to be
set up like the previously installed NVG(s).

To set up a two-armed configuration, proceed as follows:

Step

Action

1

Choose join from the Setup menu.

[Setup Menu]

join

- Join an existing iSD cluster

new

- Initialize iSD as a new installation

boot

- Boot menu

info

- Information menu

exit

- Exit

[global command, always

available]

>> Setup# join

Setup will guide you through the initial configuration

of the iSD.

2

Configure the management interface port number.

Enter port number for the management interface [1-4]: 1

Nortel VPN Gateway

User Guide

NN46120-104

02.01

Standard

14 April 2008

Copyright © 2007-2008 Nortel Networks

.