beautypg.com

Connecting to the vpn gateway, Establishing a console connection, Requirements – Nortel Networks NN46120-104 User Manual

Page 136: Procedure

background image

136

The Command Line Interface

Connecting to the VPN Gateway

You can access the command line interface in two ways:

Using a console connection through the console port

Using a Telnet connection or SSH connection over the network.

Establishing a Console Connection

A console connection is required when performing the initial setup, and
when reinstalling the NVG software as the boot user. When logging in as
root user for advanced troubleshooting purposes, a console connection
is also required.

Requirements

To establish a console connection with the VPN Gateway, you will need
the following:

An ASCII terminal or a computer running terminal emulation software
set to the parameters shown in the following table:

Table 4
Console Configuration Parameters

Parameter

Value

Baud Rate

9600

Data Bits

8

Parity

None

Stop Bits

1

Flow Control

None

A serial cable with a female DB-9 connector. (For more specific
information, see the "Connecting to the VPN Gateway " chapter in the
Hardware Installation Guide.)

Procedure

Step

Action

1

Connect the terminal to the Console port using the correct
serial cable.

When connecting to a VPN Gateway, use a serial cable with a
female DB-9 connector (shipped with the VPN Gateway).

2

Power on the terminal.

3

To establish the connection, press ENTER on your terminal.

Nortel VPN Gateway

User Guide

NN46120-104

02.01

Standard

14 April 2008

Copyright © 2007-2008 Nortel Networks

.