Nortel Networks DCT1900 - Manual (Page 283)

Technical Product Manual - DCT1900
Installation Instructions, Modular Cabinet – CLU/SLU to Base Station Cabling
Install-DCT1900/R8/mw 21-7
© 2000-2005
Record Keeping
Make a copy of the Base Station identification and location sheet included at the end of this
chapter and fill in the information as you add your Base Stations. Refer to Section 2, Chapter 5,
paragraph 5.4 in this manual for Base Station Numbering. An example of how to fill in the sheet
starting with cable pair 1 of the CLU/MDF cable TSRNB 101 29/1 (see Table 21-3) or TSRNB 101
4611 (see Table 21-2) is given in Table 21-1.
Table 21–1 Example of Base Station Administration
Note: Delay* - If you are using the SLU or CLU-S boards, then the delay will .1 for all Base
Stations.
Base
Station Id Cabinet
number CLU or SLU
board position CLC
number Delay Location of Base Station
40 1 56 1 .6 Building A, floor 1, room 100
41 1 56 2 .8 Building A, floor 2, room 122
43 1 56 3 .2 Building A, floor 2, corridor at room 050
*