Powerware 9170+ User Manual
Page 20
Installation Setup
16
Powerware
®
9170 User's Guide
S
LTM-1344 B Uncontrolled Copy
3. Pry the caps out of the bolt access holes.
4. Use a 1/2I hex-style socket wrench to turn each of the four
bolts clockwise. Doing so lowers the casters to allow the cabinet
to roll on the casters.
5. After rolling the cabinet to its intended position, turn all four
caster bolts counter-clockwise until the cabinet rests on the
floor. Place a plastic cap into each bolt access hole.
NOTE If the floor is uneven and the cabinet is tilted or unstable, you may need to
place a thin steel plate under a corner.
Do not use the caster bolts to level the
cabinet.
After properly positioning and leveling the cabinet, insert power and
battery modules into the rack as described in UPS Startup" on page 49.