Printronix MVP Series - Manual (Page 57)

Configuration 4–5
Verifying Configurations
Verify the printer configuration to ensure that the appropriate response is
received for a particular application. To verify a configuration:
1. Print out a configuration self–test using the Self Test Procedure on page
9–10to set the configuration option to 00.1. (Make sure the printer is
on–line.)
2. Compare the values of configuration options 20 through 99 with
application requirements. Refer to the “Self–Tests” in Chapter 9 for a
complete list of self–tests and instructions that apply to your type of
MVP printer.
3. Use the explanations for configuration options 20 through 99 to
determine the configuration settings selected.
NOTE: Use the explanations for configuration options 20 through 99 to
determine the configuration settings selected. Explanations for
standard MVP/L150 and 150B/L150B configuration options 20–59
begin on page 4–7. Configuration options 60 through 99 are
discussed in the Interfaces chapter. Addresses 00–19 are test and
service printout addresses.
4. Change the configuration options as necessary to meet application and
interface requirements.